Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LS, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 14 (ENGINE MECHANICAL - 2.0L)REPAIR INSTRUCTIONS - ON VEHICLEENGINE REPLACEMENTNOTES
2008 Chevrolet HHR LS, Automatic
Engine Replacement: Notes
2008 Chevrolet HHR LS, AutomaticSECTION Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools
- J 24319-B Steering Linkage and Tie Rod Puller
- J 45341 Rear Wheel Drive Shaft Removal Tool
- J-2619-A Slide Hammer
- J 44394 Axle Seal Protector
- J 45059 Angle Meter. See Special Tools .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.