Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LS, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS AND FUEL - 2.2L (L61) - DTC P0442 TO DTC P2544DTC P1682CIRCUIT/SYSTEM TESTING
2008 Chevrolet HHR LS, Automatic
Circuit/System Testing
2008 Chevrolet HHR LS, AutomaticSECTION Circuit/System Testing
- Ignition ON, observe the Ignition 1 Signal and EC Ignition Relay Feedback scan tool parameters to determine which is less than B+.
- Ignition OFF, remove the relay that corresponds to the scan tool parameter that is less than B+.
- Ignition On, connect a 3A fused jumper wire between B+ and the applicable ignition 1 circuit terminal. Verify that the applicable scan tool parameter displays B+.
- If the applicable scan tool parameter is less than the specified value, test the ignition 1 circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
- If all circuits test normal, test or replace the applicable relay.
IMPORTANT:
6 ohms or greater in the circuit/underhood fuse block will cause the DTC to set.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.