Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008EXPRESS 2500 V8-6.6L DSL TURBOREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAULREPAIR INSTRUCTIONS117. ENGINE REMOVAL FROM STAND
2008 Chevrolet Express 2500 V8-6.6L DSL Turbo
117. Engine Removal from Stand
2008 Chevrolet Express 2500 V8-6.6L DSL TurboSECTION 117. Engine Removal from Stand
Engine Removal from Stand
Tools Required
J 36857 Engine Lift Bracket
1. Bolt J 36857 to the ends of the cylinder heads.
2. Lift the engine and the engine stand with a suitable hoist.
3. Remove the engine stand from the engine adapter.
4. Lower the engine to the floor. Support the engine with blocks.
5. Remove the engine adapter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.