Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008COBALT LS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMREPAIR INSTRUCTIONSELECTRONIC TRACTION CONTROL SWITCH REPLACEMENT

2008 Chevrolet Cobalt LS, 4D Sedan, Standard

Electronic Traction Control Switch Replacement

2008 Chevrolet Cobalt LS, 4D Sedan, StandardSECTION Electronic Traction Control Switch Replacement

Fig 1: Locating Electronic Traction Control Switch

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

NOTE: Refer to Fastener Notice .

Preliminary Procedures

Remove the steering column opening filler assembly. Refer to Steering Column Opening Filler Replacement .
Tilt the steering wheel up.

Electronic Traction Control Switch Clip (Qty: 2)

Electronic Traction Control Switch Assembly

Procedure

Release the switch assembly by pulling away from the instrument panel retainer.
Disconnect the electrical connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.