Front Fog Lamp Replacement

2008 Chevrolet Cobalt LS, 4D Sedan, StandardSECTION Front Fog Lamp Replacement
Fig 1: View Of Fog Lamp Switch
GM1655541Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove either the LF or RF front fender liner. Refer to Front Fender Liner Replacement .
  3. Disconnect fog lamp bulb socket electrical connector.
1 Front Fog Lamp Adjuster Screw
Tip:Β 
  1. Remove the adjuster screw from the fog lamp bracket and lamp assembly.
  2. Count the number of turns when removing the adjuster screw for a reference upon installation.
  3. Aim the fog lamp after installation. Refer to Fog Lamp AimingΒ .
2 Front Fog Lamp Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:Β  2 N.m (18 lb in)

3 Front Fog Lamp Assembly
Tip:Β  Remove the lamp assembly from the fog lamp bracket.
4 Front Fog Lamp Bulb
CAUTION: Refer to Halogen Bulb Caution .

Tip:Β  Turn the bulb socket counterclockwise and remove from the lamp assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.