Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008COBALT LS, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC C0035-C0050CONDITIONS FOR RUNNING THE DTC
2008 Chevrolet Cobalt LS, 2D Coupe, Standard
Conditions for Running the DTC
2008 Chevrolet Cobalt LS, 2D Coupe, StandardSECTION Conditions for Running the DTC
C0035-C0050 00
- The ignition is ON.
- Ignition voltage is greater than 9.5 volts.
C0035-C0050 0F
- The ignition is ON.
- Ignition voltage is greater than 9.5 volts.
- The brake pedal is not pressed.
- A DTC is not set for the other wheel speed circuit on the same axle.
C0035-C0050 18
- The ignition is ON.
- Ignition voltage is greater than 9.5 volts.
- The brake pedal is not pressed.
- No other wheel speed circuit DTCs are set.
- At least two other wheel speeds are not 0 km/h.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.