Rear Side Door Window Regulator Replacement (Manual Sedan)

2008 Chevrolet Cobalt LS, 2D Coupe, StandardSECTION Rear Side Door Window Regulator Replacement (Manual Sedan)
Fig 1: Window Regulator Replacement - Rear Door (Manual Sedan)
GM1548957Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the interior trim panel. Refer to Rear Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  3. Move the window to the full up position and secure in place with tape.
1 Side Door Window Regulator Bolt (Qty: 4)
NOTE: Refer to Fastener Notice .

Tip:Β  Loosen the bolts enough so that the regulator assembly will lift out of the t-slots in the door inner panel.

Tighten:Β  10 N.m (89 lb in)

2 Rear Side Door Window Regulator Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.