Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008COBALT LS, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEMREPAIR INSTRUCTIONSWASHER PUMP REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet Cobalt LS, 2D Coupe, Standard
Removal Procedure
2008 Chevrolet Cobalt LS, 2D Coupe, StandardSECTION Removal Procedure
- Drain the washer solvent from the washer solvent container.
- Remove the front fender liner. Refer to Front Fender Liner Replacement .
- Disconnect the washer pump electrical connector.
- Disconnect the washer pump hose.
- Using a small flat-bladed tool, remove the washer pump from the washer solvent container.
- Using a small flat-bladed tool, remove the seal from the washer solvent container.
Fig 1: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.