Removal Procedure

2008 Chevrolet Chevy Express H1500, Van Passenger, GasSECTION Removal Procedure
    Fig 1: Wiper Motor Electrical Connector
    GM497992Courtesy of GENERAL MOTORS CORP.
  1. Remove the wiper arms. Refer to Windshield Wiper Arm ReplacementΒ .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel ReplacementΒ .
  3. Disconnect the electrical connector from the wiper motor.
  4. Fig 2: Wiper Motor, Cover & Screws
    GM781418Courtesy of GENERAL MOTORS CORP.
  5. Remove the 3 screws (2) and the wiper motor cover (3) from the wiper motor (1).
  6. Remove the wiper motor cover (3).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.