Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS H1500, VAN PASSENGER, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSFIXED & MOVEABLE WINDOW SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESPOWER WINDOWS MALFUNCTIONCIRCUIT/SYSTEM TESTINGDRIVER WINDOW MALFUNCTION
2008 Chevrolet Chevy Express H1500, Van Passenger, Gas
Driver Window Malfunction
2008 Chevrolet Chevy Express H1500, Van Passenger, GasSECTION Driver Window Malfunction
- Ignition OFF, disconnect the harness connector at the driver window switch.
- Test for less than 1 ohm between the ground circuit terminal F and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal C and ground.
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
- Ignition OFF, connect the harness connector at the driver window switch and disconnect the harness connector at the driver window motor.
- Test for less than 1 ohm between the control circuit terminal B and ground.
- If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the driver window switch.
- Test for less than 1 ohm between the control circuit terminal A and ground.
- If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the driver window switch.
- Connect a test lamp between control circuit terminal B and control circuit terminal A.
- Ignition ON, command the driver door window UP and DOWN using the driver window switch. The test lamp should illuminate when commanding the UP and DOWN states.
- If the test lamp does not illuminate during either of the commands, test both control circuits for a short to ground. If the circuits test normal, test or replace the driver window switch.
- If all circuits tests normal, test or replace the driver window motor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.