Component Testing

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Component Testing
WARNING: This page is about a different variant/trim than selected.
IMPORTANT: You must perform the Circuit/System Testing before proceeding with Component Testing.
  1. Inspect the CKP sensor for correct installation. Remove the CKP sensor from the engine and inspect the sensor O-ring for damage.
    • If the sensor is loose, incorrectly installed, or damaged, replace the CKP sensor.
  2. Connect the CKP sensor harness connector to the CKP sensor.
  3. Ignition ON, engine OFF. Observe the CKP Active counter parameter on the scan tool.
  4. Pass a flat steel object across the tip of the sensor repeatedly. The CKP Active counter parameter should increment with each pass of the steel object.
    • If the parameter does not increment, replace the CKP sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.