Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Air Cleaner Assembly
    GM1662672Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the mass air flow (MAF) harness connector.
  2. Remove the air cleaner assembly hold down screw.
  3. Loosen the air cleaner outlet duct hose clamp.
  4. Remove the air cleaner assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.