Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The exhaust gas temperature sensors are variable resistors that measure the temperature of the exhaust gas at the inlet and outlet of the diesel particulate filter (DPF). The engine control module (ECM) supplies a bias 5-volt signal to the EGT signal circuit, and supplies a ground to the low reference circuit. When the EGT sensor is cold, the sensor resistance is low. When the EGT temperature increases, the sensor resistance increases. With high sensor resistance, the ECM detects a higher voltage on the EGT signal circuit. With lower sensor resistance, the ECM detects a lower voltage on the EGT signal circuit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.