Circuit/System Testing

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Perform the Repair Verification after completing the Circuit/System Testing.

Verify the integrity of the entire exhaust system by visually inspecting for the following conditions:

  • Damaged exhaust system components
  • Loose or improperly installed exhaust system components
  • Leaks, or improperly routed pressure lines-The smaller tube connects to the front of the DPF. The lines should have a continuous downward gradient, without sharp bends, or kinks from the differential pressure sensor to the exhaust particulate filter assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.