Conditions for Running the DTC

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
  • DTCs P0106, P0107, P0108, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0442, P0443, P0449, P0451, P0452, P0453, P0454, P0464, P0496, P0608, P0609, P0641, P0651, P1516, P2101, P2119, P2120, P2122, P2123, P2125, P2127, P2128, P2135, P2138 are not set.
  • The ignition voltage is between 11-18 volts.
  • The barometric pressure (BARO) is more than 74 kPa.
  • The fuel level is between 15-85 percent.
  • The engine coolant temperature (ECT) is less than 35Β°C (95Β°F).
  • The intake air temperature (IAT) is between 4-30Β°C (39-86Β°F).
  • DTC P0446 runs once per cold start when the above conditions are met.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.