Conditions for Running the DTC

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
  • DTCs P0117, P0118, P0335, P0336, P2146, P2149, P2152, P2155 and P062C are not set.
  • The ECT is more than 40Β°C (104Β°F).
  • The engine is running at idle for more than 10 seconds.
  • The engine RPM is between 500-1,300 RPM.
  • The vehicle speed is less than 3 mph.
  • The calculated fuel rate is between 3 mm3 and 25 mm3 .
  • DTCs P0300-P0308 will run once per ignition cycle when the above conditions are met.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.