Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L (LMM) - DTC P0016 TO DTC P0299)DTC P0230CIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Circuit/System Verification
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Install the CH-48027 to the fuel system service port on the right from side of the engine. Command the fuel pump on, using a scan tool and observe the fuel pressure gage. Fuel pressure should be a minimum of 69 kPa (10 psi) with the fuel pump running.
- Engine running, observe the DTC information with a scan tool. DTC P0230 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame Records data.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.