Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L (LMM) - DTC P0016 TO DTC P0299)DTC P0181CONDITIONS FOR SETTING THE DTC
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Conditions for Setting the DTC
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
- The fuel temperature and the IAT Sensor 1 are more than 100°C (180°F) of each other at start-up.
OR
- The fuel temperature and the IAT Sensor 1 are more than 10°C (18°F) of each other at start-up.
AND
- The IAT has not dropped more than 2.5°C (4.5°F) after running more than 6 minutes above 24 km/h (15 mph).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.