Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
Fuel is drawn from the fuel tank through the fuel heater, then to the fuel injection pump. Fuel temperature is monitored by the fuel temperature sensor, which is located in the fuel return line on the engine. The engine control module (ECM) supplies 5 volts and a ground circuit to the sensor. When the ECM detects a fuel temperature above the pre-determined value, this diagnostic will fail, but will not turn the malfunction indicator lamp (MIL) ON.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.