SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 996 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEW 3 OF 5)LIFTGATE WINDOW LATCH ASSEMBLY (E52)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Liftgate Window Latch Assembly (E52)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Liftgate Window Latch Assembly (E52)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Liftgate Window Latch Assembly (E52) Connector End View
GM1711027Courtesy of GENERAL MOTORS CORP.
Liftgate Window Latch Assembly (E52)

Pin Wire Color Circuit Function
1 0.35 L-BU 6795 Liftglass/Trunk Motor Release Control 2
2 0.5 BK 1450 Ground
3 0.5 BK 1450 Ground
4 0.35 PK/BK 1303 Liftgate Ajar Switch Signal (E52 without E61)
0.35 PU 2279 Liftglass Ajar Switch Signal (E61)
Connector Part Information 
  • OEM: 15489983
  • Service: 88988815
  • Description: 4-Way F Timer Micro-Pack III Series Sealed (WH)
Terminal Part Information 
  • Terminal/Tray: 4-969005-1/16
  • Core/Insulation Crimp: E/1
  • Release Tool/Test Probe: J-38125-560/J-35616-33 (YE)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.