SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 982 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC COMPASS MODULE TO MEMORY SEAT MODULE (X4))COMPONENT CONNECTOR END VIEWSINFLATABLE RESTRAINT PASSENGER PRESENCE SYSTEM (PPS) SENSOR (HP2)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Inflatable Restraint Passenger Presence System (PPS) Sensor (HP2)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Inflatable Restraint Passenger Presence System (PPS) Sensor (HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM1962078Courtesy of
Connector Part Information
  • Harness Type: Passenger Seat
  • OEM Connector: 13511996
  • Service Connector: 19149288
  • Description: 3-Way F GT 150 Series Sealed (GY)
Terminal Part Information
  • Terminal/Tray: Service by Component - See Part Catalog
  • Core/Insulation Crimp: Not Available
  • Release Tool/Test Probe: Not Available
Inflatable Restraint Passenger Presence System (PPS) Sensor (HP2)

Pin Wire Circuit Function
1 0.35 D-GN 5609 Occupant Pressure Sensor Voltage Reference
2 0.35 YE 5608 Occupant Pressure Sensor Signal
3 0.35 GY 5610 Low Reference
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.