Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the window to the down position.
  2. Fig 1: View Of Screws And Window Channel
    GM1226148Courtesy of GENERAL MOTORS CORP.
  3. Remove the trim panel. Refer to Front Side Door Trim Panel Replacement .
  4. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  5. Remove the outside door mirror. Refer to Outside Rearview Mirror Replacement .
  6. Remove the outer belt sealing strip. Refer to Front Side Door Window Belt Outer Sealing Strip ReplacementΒ .
  7. Remove the screw from the window channel.
  8. Remove the window channel from the front door frame.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.