Accessory Power Receptacle Replacement (HP2)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Accessory Power Receptacle Replacement (HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Accessory Power Receptacle
GM2002463Courtesy of GENERAL MOTORS COMPANY
Accessory Power Receptacle Replacement (HP2)

Callout Component Name
1 Rear Seat Cup Holder
ProcedureΒ 
Remove cup holder to access receptacle.
2 Accessory Power Receptacle

Procedure

  1. Squeeze tabs to unsnap the receptacle from the left side rear quarter trim panel.
  2. Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.