Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 919 (POWER STEERING SYSTEM)SPECIAL TOOLS AND EQUIPMENTSPECIAL TOOLS
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Special Tools
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Special Tools
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
| Illustration | Tool Number/ Description |
|---|---|
| CH-49009 Inner Tie Rod Wrench |
|
| GE-28431-6 J-28431-6 Fluorescent Dye |
|
| J-4245 Internal Snap Ring Pliers |
|
| J-6219 Pitman Shaft Seal Installer |
|
| J-6278 Bearing Remover and Installer |
|
| J-8001 Dial Indicator Set |
|
| J-22610 Keystone Clamp Pliers |
|
| J-24319-B Steering Linkage and Tie Rod Puller |
|
| J-25033-C Pulley Installer |
|
| J-25034-C Pulley Remover |
|
| J-39570 Chassis Ear |
|
| J-44586 Power Steering Gear Oil Seal Remover/Installer |
|
| J-44721 Power Steering Analyzer |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.