Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 9 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSTAIL LAMP REPLACEMENT (CADILLAC)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Tail Lamp Replacement (Cadillac)
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Tail Lamp Replacement (Cadillac)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Tail Lamp Replacement (Cadillac)
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Open the liftgate in order to access the tail lamp assembly screws. |
|
| 1 | Tail Lamp Assembly Screws (Qty: 2)
NOTE:
Refer to Fastener Notice
.
Tighten: 2 N.m (18 lb in) |
| 2 | Tail Lamp Assembly Locator Pins (Qty: 2) Tip: Upon tail lamp removal, some effort is needed to disengage the locating pins from the rear body panel retainer nuts. |
| 3 | Tail Lamp Retainers (Qty: 2) |
| 4 | Tail Lamp Wiring Harness Assembly Connector |
| 5 | Tail Lamp Assembly Tip: Upon installation of the tail lamp, push inward on the lamp in order to seat the 2 locator pins into the retainer nuts. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.