Radiator Surge Tank Replacement (Non-HP2)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Radiator Surge Tank Replacement (Non-HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radiator Surge Tank (Non-HP2)
GM2042841Courtesy of GENERAL MOTORS COMPANY
Radiator Surge Tank Replacement (Non-HP2)

Callout Component Name

Preliminary Procedures

  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
  2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
1 Surge Tank Bolt
CAUTION:

Refer to Fastener Caution .


Tighten 
10 (89 lb in)
2 Surge Tank Nut
Tighten 
10 (89 lb in)
3 Surge Tank

Procedure

  1. Remove the surge tank hoses from the surge tank.
  2. Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.