Liftgate Side Upper Sensor Replacement (Except Avalanche and EXT Escalade)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Liftgate Side Upper Sensor Replacement (Except Avalanche and EXT Escalade)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Liftgate Side Upper Sensor
GM1687321Courtesy of GENERAL MOTORS COMPANY
Liftgate Side Upper Sensor Replacement (Except Avalanche and EXT Escalade)

Callout Component Name

Preliminary Procedures

  1. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  2. Disconnect the electrical connector.
1 Sensor Side Upper Liftgate Retainers (Qty: 4)
TIP:Β  The retainers are ONE time use ONLY. They must be replaced after being removed.
2 Sensor Side Upper Liftgate
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.