Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 891 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSLIFTGATE RELEASE SWITCH REPLACEMENT (EXCEPT AVALANCHE AND ESCALADE EXT)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Liftgate Release Switch Replacement (Except Avalanche and Escalade EXT)
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Liftgate Release Switch Replacement (Except Avalanche and Escalade EXT)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Liftgate Release Switch Replacement (Except Avalanche and Escalade EXT)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the liftgate handle. Refer to Liftgate Outside Handle Replacement (Except Avalanche and EXT Escalade) . |
|
| 1 | Liftgate Release Switch Screw (Qty: 4)
CAUTION:
Refer to Fastener Caution . Tighten 2 N.m (18 lb in) |
| 2 | Liftgate Release Switch TIP: Disconnect the electrical connector. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.