SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 890 (FIXED AND MOVEABLE WINDOWS)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REAR CHANNEL REPLACEMENT
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Front Side Door Window Rear Channel Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Front Side Door Window Rear Channel Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Side Door Window Channels & Components
GM1685772Courtesy of GENERAL MOTORS COMPANY
Front Side Door Window Rear Channel Replacement

Callout Component Name

Preliminary Procedures

  1. Position the door window as needed for service.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Front Door Window Run Channel Rear Bolt
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Front Door Window Rear Run Channel
TIP:  Raise the door window to the fully close position to gain access the run channel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.