Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 889 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSENGINE GROUND STRAP REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Installation Procedure
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ground strap to the vehicle.
- Install the ground strap terminal to the stud.
- Install the engine ground strap nut at the front plenum panel.
Tighten
Tighten the nut to 9 N.m (80 lb in).
- Position the ground strap to the rear of the left cylinder head.
Tighten
Tighten the bolt to 16 N.m (12 lb ft).
- Install the engine ground strap bolt to the rear of the left cylinder head.
- Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.