Rearview Camera Replacement (Endgate)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Rearview Camera Replacement (Endgate)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rearview Camera Components
GM2230742Courtesy of GENERAL MOTORS COMPANY
Rearview Camera Replacement (Endgate)

Callout Component Name
Preliminary Procedure 
Remove the endgate latch handle bezel. Refer to Pickup Box Endgate Latch Handle Bezel Replacement (Pickup) .
1 Endgate Access Panel Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Endgate Access Panel
3 Rearview Camera Screw (Qty: 3)
4 Rearview Camera

Procedure

  1. Route the electrical harness through the guide.
  2. Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.