SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 871 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT LEVEL INDICATOR REPLACEMENT
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Windshield Washer Solvent Level Indicator Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Windshield Washer Solvent Level Indicator Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Windshield Washer Solvent Level Indicator & Grommet
GM1685044Courtesy of GENERAL MOTORS COMPANY
Windshield Washer Solvent Level Indicator Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the windshield washer container. Refer to Windshield Washer Solvent Container Replacement .
  2. Using 2 flat-bladed tools, gently pry the windshield washer solvent level indicator from the side of the washer container.
  3. Discard the old windshield washer solvent level indicator grommet.
1 Windshield Washer Solvent Level Indicator
TIP:  Ensure the square edge faces upward upon installation of the new level indicator.
2 Windshield Washer Solvent Level Indicator Grommet
TIP:  Discard the old grommet and use the new grommet in the kit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.