SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 847 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULE)COMPONENT CONNECTOR END VIEWSHEATED SEAT ELEMENT - LEFT REAR CUSHION (KA6)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Heated Seat Element - Left Rear Cushion (KA6)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Heated Seat Element - Left Rear Cushion (KA6)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Seat Element - Left Rear Cushion (KA6) Connector End View
GM283890Courtesy of GENERAL MOTORS CORP.
Heated Seat Element- Left Rear Cushion (KA6)

Pin Wire Circuit Function
A 1 PK 2445 Heated Seat Element Control
B 1 BN 2295 Ground
C 0.35 L-BU 2299 Left Rear Heated Seat Sensor Signal
D 0.35 D-BU 2298 Low Reference
Connector Part Information
  • Harness Type: Left Rear Seat
  • OEM Connector: 12066498
  • Service Connector: 12085536
  • Description: 4-Way F Metri-Pack 150 Series (BK)
Terminal Part Information
  • Terminal/Tray: Service by Harness- See Part Catalog
  • Core/Insulation Crimp: Not Available
  • Release Tool/Test Probe: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.