SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 841 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSCRANKSHAFT POSITION (CKP) SENSOR
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Crankshaft Position (CKP) Sensor

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Crankshaft Position (CKP) Sensor
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Crankshaft Position (CKP) Sensor Connector End View
GM684840Courtesy of GENERAL MOTORS CORP.
Crankshaft Position (CKP) Sensor

Pin Wire Circuit Function
A 0.35 WH/BK 6271 Crankshaft Position (CKP) Sensor Signal
B 0.35 GY/BK 6272 Low Reference
C 0.35 PU/WH 6270 5-Volt Reference
Connector Part Information
  • Harness Type: Engine
  • OEM Connector: 12129946
  • Service Connector: 88987997
  • Description: 3-Way F Metri-Pack 150 Series Sealed (GY)
Terminal Part Information
  • Terminated Lead: 13575419
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-14 (GN)
  • Terminal/Tray: 12048074/2
  • Core/Insulation Crimp: E/1
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.