SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 841 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSBLOWER MOTOR CONTROL MODULE- AUXILIARY X1 (C69)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Blower Motor Control Module- Auxiliary X1 (C69)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Blower Motor Control Module- Auxiliary X1 (C69)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Blower Motor Control Module- Auxiliary X1 (C69) Connector End View
GM1837857Courtesy of GENERAL MOTORS CORP.
Blower Motor Control Module- Auxiliary X1 (C69)

Pin Wire Circuit Function
1 0.35 RD/WH 1740 Battery Positive Voltage
2 0.35 OG 5988 Low Reference
Connector Part Information
  • Harness Type: Auxiliary HVAC
  • OEM Connector: 10846816
  • Service Connector: 88988507
  • Description: 2-Way F 6.3 Series (GY)
Terminal Part Information
  • Terminal/Tray: Service by Harness- See Part Catalog
  • Core/Insulation Crimp: Not Available
  • Release Tool/Test Probe: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.