Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 816 (REAR SUSPENSION SYSTEM)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Section 816 (Rear Suspension System)
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Section 816 (Rear Suspension System)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Repair Instructions
- Rear Axle Upper Control Arm Replacement
- Rear Axle Lower Control Arm Replacement
- Stabilizer Shaft Replacement
- Stabilizer Shaft Insulator Replacement
- Stabilizer Shaft Link Replacement
- Strut and Shock Absorber Inspection (Shock Absorber)
- Shock Absorber Replacement (1500)
- Shock Absorber Replacement (2500)
- Shock Absorber Disposal
- Coil Spring Replacement
- Jounce Bumper Replacement (1500)
- Jounce Bumper Replacement (2500)
- Leaf Spring Replacement (2500 Series)
- Rear Spring Shackle Replacement (2500)
- Rear Axle Tie Rod Replacement
- Wheel Stud Replacement
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.