SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 771 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSFRONT BRAKE CALIPER HARDWARE REPLACEMENT (1500 SERIES)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    2. NOTE:

    Support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake hose from the caliper.

  2. Remove the brake caliper from the caliper bracket. Refer to Front Brake Caliper Replacement (1500 Series) , Front Brake Caliper Replacement (2500 Series) .
    3. Fig 1: Caliper Bracket And Pads
    GM1479405Courtesy of GENERAL MOTORS CORP.
  3. Remove the brake pads from the caliper bracket.
  4. Remove the brake pad retainers.
    5. Fig 2: Caliper Pins, Seals And Bushings
    GM1479416Courtesy of GENERAL MOTORS CORP.
  5. Remove the caliper pins, seals, and bushings from the caliper bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.