Brake Fluid Level Indicator Switch Replacement (Two-mode Hybrid)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Brake Fluid Level Indicator Switch Replacement (Two-mode Hybrid)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Brake Fluid Level Indicator Switch (Two-mode Hybrid)
GM1892198Courtesy of GENERAL MOTORS CORP.
Brake Fluid Level Indicator Switch Replacement (Two-mode Hybrid)

Callout Component Name

Preliminary Procedures

  1. Place the ignition switch in the OFF position.
  2. Disconnect the brake fluid level sensor electrical connector.
1 Brake Fluid Level Sensor
TIP:Β  Compress the brake fluid level sensor locking tabs on the opposite side of the master cylinder reservoir to remove.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.