Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 763 (POWER SEAT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER SEAT INOPERATIVE (WITHOUT MEMORY A45)CIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Circuit/System Verification
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Operate the switches for the seat directional motors listed below in both directions. The seat should move in the commanded directions.
- Horizontal Motor
- Front Vertical Motor
- Rear Vertical Motor
- Recline Motor
- If the power seat is inoperative in all directions, refer to the Seat Adjuster Switch Circuit Test below.
- If just the seat recline function is inoperative, refer to the Recline Motor Circuit Test below.
- If 1 or more of the seat adjuster motors operate, refer to the appropriate Seat Adjuster Motor Circuit Test below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.