Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 755 (FRAME AND UNDERBODY)REPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE SPLASH SHIELD REPLACEMENT
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Electronic Brake Control Module Splash Shield Replacement
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Electronic Brake Control Module Splash Shield Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Electronic Brake Control Module Splash Shield Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . |
|
| 1 | Electronic Brake Control Module Splash Shield Retainer (Qty: 2) |
| 2 | Electronic Brake Control Module Splash Shield Bolt (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 20 N.m (15 lb ft) |
| 3 | Electronic Brake Control Module Splash Shield |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.