Assist Step Controller Replacement (Power BRS)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Assist Step Controller Replacement (Power BRS)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Assist Step Controller
GM1811263Courtesy of GENERAL MOTORS CORP.
Assist Step Controller Replacement (Power BRS)

Callout Component Name
1 Power Assist Step Controller Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


TightenΒ 
6 N.m (53 lb in)
2 Power Assist Step Controller

Procedure

  1. Disconnect any electrical connectors.
  2. Reprogram the new controller if necessary. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.