Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 754 (WIRING SYSTEMS AND POWER MANAGEMENT - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSIGNITION LOCK CYLINDER CASE REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Installation Procedure
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ignition lock cylinder case (1) to the vehicle.
- Install the 3 ignition lock cylinder case screws (2).
Tighten
Tighten the screws to 7 N.m (62 lb in).
- Install the park lock cable into the lock cylinder housing.
- Connect the passlock and key buzzer to the ignition lock cylinder case.
- Install the ignition/start switch. Refer to Ignition and Start Switch Replacement .
- Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Airbag Coil Replacement .
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.