Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 752 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSDOOR STRIKER REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Removal Procedure
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
If both of the door striker bolts are removed at the same time, the striker backing plate will fall into the body. This will result in additional time to perform the repair.
- Remove the lower striker bolt.
- Loosen the upper striker bolt enough in order to rotate the striker and the spacer, if equipped, away from the lower bolt hole.
- Install the lower striker bolt. Tighten the lower striker bolt sufficiently in order to hold the striker backing plate in place.
- Remove the upper striker bolt (1).
- Remove the spacer, if equipped.
- Remove the striker (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.