Repeater Lamp Replacement (Escalade)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Repeater Lamp Replacement (Escalade)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Repeater Lamp Assembly
GM1669897Courtesy of GENERAL MOTORS CORP.
Repeater Lamp Replacement (Escalade)

Callout Component Name
Preliminary ProcedureΒ 
Remove the front wheelhouse assembly. Refer to Front Wheelhouse Liner Replacement - Left Side , or Front Wheelhouse Liner Replacement - Right Side .
1 Repeater Lamp Connector
2 Repeater Lamp Tabs (Qty: 2)
TIP:Β  Release the tabs securing the repeater to the fender.
3 Repeater Lamp Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.