SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 731 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSFRONT FOG LAMP REPLACEMENT (PLATINUM)
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Front Fog Lamp Replacement (PLATINUM)

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Front Fog Lamp Replacement (PLATINUM)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Fog Lamp Assembly And Components
GM1767120Courtesy of GENERAL MOTORS CORP.
Front Fog Lamp Replacement (PLATINUM)

Callout Component Name

Preliminary Procedures

  1. Remove the front lower bumper filler. Refer to Front Bumper Filler Replacement (Z71) , Front Bumper Filler Replacement (All Utility, Avalanche, Cadillac EXT) .
  2. Disconnect the electrical connectors for the front park turn signal lamp and the front fog lamp sockets.
  3. The bulbs can be removed after the lamp housing has been removed from the front bumper fascia.
1 Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Front Fog Lamp Assembly
TIP:  Remove the lamp assembly from the front side of the lower bumper fascia.
3 Fog Lamp Bulb
WARNING:

Refer to Halogen Bulb Warning .


TIP:  Rotate the bulb socket counterclockwise in order to remove.
4 Park, Turn Signal Lamp Bulb Socket
TIP:  Rotate the bulb socket counterclockwise in order to remove.
5 Park, Turn Signal Lamp Bulb
TIP:  Pull the bulb straight from the socket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.