SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 729 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSAIR INLET GRILLE PANEL REPLACEMENT
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Air Inlet Grille Panel Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Air Inlet Grille Panel Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Inlet Grille Panel
GM1673096Courtesy of GENERAL MOTORS CORP.
Air Inlet Grille Panel Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the fixed antenna, if equipped. Refer to Radio Antenna Replacement .
  2. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (Chevrolet Hybrid Two-mode) , Windshield Wiper Arm Replacement (Conventional) .
  3. Remove the rear hood seal. Refer to Hood Rear Seal Replacement .
1 Air Inlet Panel End Panel
2 Air Inlet Panel Retainer (Qty: 2)
3 Air Inlet Panel Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
4 Air Inlet Panel Clip
5 Air Inlet Panel
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.