Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the appropriate belt off the power steering pump pulley. Refer to Air Conditioning Compressor and Power Steering Pump Belt Replacement for the 3.6L (LY7) engine or Water Pump and Air Conditioning Compressor and Power Steering Pump Belt Replacement for the 4.6L (LH2) engine.
  2. Fig 1: Power Steering Pump Pulley Remover
    GM649303Courtesy of GENERAL MOTORS CORP.
  3. Remove the power steering pump pulley using remover J 25034-CΒ  . See Special ToolsΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.