SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 642 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSCHECKING AND ADDING POWER STEERING FLUID
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Checking and Adding Power Steering Fluid

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Checking and Adding Power Steering Fluid
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks.
  1. Clean the area surrounding the reservoir cap.
  2. Remove the reservoir cap.
  3. Inspect the power steering pump fluid level at regular intervals. Use the appropriate procedure below.

    Add fluid when required. Refer to Fluid and Lubricant Recommendations (USA and Canada) .

    Fluid Is Hot

    1. Run the engine until the fluid reaches about 80°C (170°F).
    2. Turn the engine OFF.
    3. Remove the reservoir cap.
    4. Inspect the fluid level on the capstick.
    5. Ensure that the fluid level is at the HOT/FULL/MAX mark on the capstick.
  4. If the fluid level is low, add power steering fluid to the proper level.
  5. Install the reservoir cap.
  6. When checking the fluid level after servicing the steering system, bleed the air from the system. Refer to Power Steering System Bleeding .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.