Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Descriptors
- DTC C0186 00
-
General Failure (EBCM)
- DTC C0186 09
-
Lateral Accelerometer Circuit Rate of Change Above Threshold (VSCM)
- DTC C0186 1A
-
Lateral Accelerometer Circuit Bias Level Out Of Range (VSCM)
- DTC C0186 3B
-
Lateral Accelerometer Circuit Erratic Internal Self Test Failed (VSCM)
- DTC C0186 75
-
Lateral Accelerometer Circuit Signal Above Allowable Range (VSCM)
- DTC C0196 00
-
General Failure (EBCM)
- DTC C0196 09
-
Yaw Rate Circuit Rate of Change Above Threshold (VSCM)
- DTC C0196 1A
-
Yaw Rate Circuit Bias Level Out Of Range (VSCM)
- DTC C0196 3B
-
Yaw Rate Sensor Internal Self Test Failed (VSCM)
- DTC C0196 75
-
Yaw Rate Circuit Signal Above Allowable Range (VSCM)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.