Component Connector End Views - A Through C

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Component Connector End Views - A Through C
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Component Connector End Views - A Through C

Description
A/C Compressor Clutch
A/C Refrigerant Pressure Sensor
Accelerator Pedal Position (APP) Sensor
Accessory Power Outlet - Center Console Compartment
Accessory Power Outlet - Center Console (without DT4)
Accessory Power Outlet - I/P (without DT4)
Air Quality Sensor (K14)
Air Temperature Actuator - Auxiliary
Air Temperature Actuator - Left
Air Temperature Actuator - Right
Air Temperature Sensor - Inside
Ambient Air Temperature Sensor
Audio Amplifier X1
Audio Amplifier X2
Audio/Video Adapter (YQ4 or YQ6 or YQ7)
Automatic Headlamp Dimming Relay (TQ5)
Automatic Level Control (ALC) Compressor (F55)
Automatic Transmission Shift Lever
Backup Lamp - Left
Backup Lamp - Right
Battery (-)
Battery (+)
Battery Current Sensor
Blower Motor
Blower Motor Control Module X1
Blower Motor Control Module X2
Brake Booster Pump - Auxiliary (LLT)
Brake Fluid Level Switch
Brake Fluid Pressure Sensor (without JL7)
Brake Pedal Position Sensor
Camshaft Position (CMP) Actuator Solenoid Valve - Bank 1 Exhaust (LH2)
Camshaft Position (CMP) Actuator Solenoid Valve - Bank 1 Exhaust (LLT)
Camshaft Position (CMP) Actuator Solenoid Valve - Bank 1 Intake (LH2)
Camshaft Position (CMP) Actuator Solenoid Valve - Bank 1 Intake (LLT)
Camshaft Position (CMP) Actuator Solenoid Valve - Bank 2 Exhaust (LH2)
Camshaft Position (CMP) Actuator Solenoid Valve - Bank 2 Exhaust (LLT)
Camshaft Position (CMP) Actuator Solenoid Valve - Bank 2 Intake (LH2)
Camshaft Position (CMP) Actuator Solenoid Valve - Bank 2 Intake (LLT)
Camshaft Position (CMP) Sensor - Bank 1 Exhaust (LH2)
Camshaft Position (CMP) Sensor - Bank 1 Exhaust (LLT)
Camshaft Position (CMP) Sensor - Bank 1 Intake (LH2)
Camshaft Position (CMP) Sensor - Bank 1 Intake (LLT)
Camshaft Position (CMP) Sensor - Bank 2 Exhaust (LH2)
Camshaft Position (CMP) Sensor - Bank 2 Exhaust (LLT)
Camshaft Position (CMP) Sensor - Bank 2 Intake (LH2)
Camshaft Position (CMP) Sensor - Bank 2 Intake (LLT)
Center High Mounted Stop Lamp (CHMSL)
Cigar Lighter - Front (DT4)
Cigar Lighter - Rear (DT4)
Control Solenoid Valve Assembly X1
Control Solenoid Valve Assembly X2
Control Solenoid Valve Assembly X3
Coolant Pump - Auxiliary (LLT)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.